Bubbles

It’s common to have small bubbles after installation using the wet method.  However, water under the surface will slowly dry out, and the bubbles will eventually go away leaving a clean finish.  This is the reason why we highly recommend using the wet method for large and/or difficult installations.

Here’s an example of a typical surface right after installation:

Here’s the same surface after several weeks, where most bubbles have dried out:

Winkled edges

It’s common to have wrinled edges, since you’re applying a flat vinyl on a curved surface.  However, it can be solved by introducing heat slowly to allow the film to shrink and curve to the surface.   If there’s a big wrinkle, separate them into smaller and easier to work parts.  Remember not to rush it, too much heat or too much force applied to the surface of the film will leave undesireable results.